Tool To Tuck Carpet Under Baseboard

I use a standard carpet knife only.

Tool to tuck carpet under baseboard.

Some pieces won t be straight while others may have blemishes in the wood. Achieve finished wall edges with the roberts ez tuck carpet tucker. This non marring tool won t damage paint for worry free tucking. The way i was taught was to tuck under the trim and then cut it off under the trim.

Continue along the wall then trim excess with the wall trimmer and tuck the edge underneath the baseboard. Look through your selection of baseboard pieces for damaged ones. Reach in front of the power stretcher to hook the carpet onto the tack strip. Use a scrap board to prevent damage to the baseboard.

Flush cutting was a little more challenging in that you had to jam the carpet hard into the corner made by the wall trim and the floor and cut directly into the apex. I trust sam is using one of these tools to cut his carpet. Make a point to leave about a quarter of an inch overlapping the hard surface flooring before tucking it in place. This should seem obvious but well if you make the gap under the baseboards too small for the flooring to fit then a hammer and a wonder bar might be the only tools to get you to the end of your flooring install job.

Push the lever down to stretch the carpet taut. Order more baseboard trim than you need. This is not a good idea and will in most cases make it tougher on the carpet layers. The amount of carpet requiring trim will depend considerably on the thickness of the carpet and how far it was stretched over the tack strip.

Cut the damaged ones into four. How to install base board trim for carpet areas. Nail carpet tack strips around the perimeter of the room. Trim the carpet back before tucking it.

If you re going to install baseboards before installing the floor you have to make sure you have the proper gap to allow the flooring to get tucked under the baseboards. How to install carpet under baseboards. Use these to make sample. Position them parallel.

The tapered blade has 1 square and 1 curved corner for tucking at several locations during carpet installation or restretching. Some carpenters place the trim down to the subfloor or to the wood flooring. But baseboard installation for carpet is a bit different than the norm.