Tongue And Groove Vinyl Flooring Installation

Step 3 apply glue and attach boards.

Tongue and groove vinyl flooring installation.

Installing tongue and groove floors engineered pre finished or bare wood is among the most popular diy projects and for good reason. Install the second plank by holding it at an angle and inserting its tongue edge into the first plank s groove edge. Installing tongue and groove walls can be a real workout. Step 2 begin laying the boards.

Install the second plank next to the first by aligning the tongue into the groove and press the plank down to snap it in place. Floating floor step 1 underlayment. B insert the short end of the second plank into the short end of the first plank as shown offset the planks by about 1 2. Lower the plank down until the joint closes.

A angle the first plank at a 20 angle and insert the long side tongue into the groove edge of the first row. The short width sides of tongue and groove flooring planks also feature. Lower the second plank to snap the planks together. Begin the first row of flooring by placing the planks with the tongue side facing the wall.

Trim the short tongue edge from the first vinyl plank. If necessary you can apply a layer of vapor barrier to the floor and then you need to roll out. Each floor board can slide into place because the tongue side can slide into the groove side. Tongue and groove also known as click lock vinyl is one of the simplest ways to install vinyl flooring.

You don t need a truck load of tools to do a good job installing them and once you get the hang of it you can work like a pro. Lay the first plank appropriately spaced from the wall. Pros of tongue and groove flooring. This type of installation requires no tape or adhesive and creates a floating floor.

Be sure that your first board is placed with the tongue edging pointing into the room. 3 tongue and groove isn t always flat so you have to force the boards together to get them seated. Tongue and groove flooring has a tongue side that sticks out and a receiving groove side that is indented. 1 you re usually working over your head.

When you come to the end of the first row cut the length of plank needed to complete the row.