Sunsetter Awning Led Lights Not Working

You get a set of lights for each arm plus a waterproof transformer box that converts 110 volt to 12 volt to save energy.

Sunsetter awning led lights not working.

Plug in the power cord and close the awning the rest of the way. Not available for the 1000xt model awning. Be sure to order dimming led lights for your sunsetter awning. Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system.

How to use the multi channel remote transmitter see figures 13 14. Control box the first time the led light system is plugged in. Step 1 push the middle button on the remote control and unplug the awning s power cord from the electrical outlet. Control box the first time the led light system is plugged in.

If the remote control stops working with the awning it needs to be reset. Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system. Press and hold my for 8 seconds the light should blink the entire time. T z z á z u o u µ o o ç v z o µ o z á v v p o v p x.

As you continue to hold the down button the led lights will dim down to fully off. The reset process appears convoluted but when followed closely it will reconnect the remote control with the motor control unit. Verify that the red light on the remote transmitter comes on when you press and hold the button. You should always troubleshoot your awning before calling the manufacturer to see if you can solve the problem yourself.

The awning s settings and electricity supply are also common sources of trouble. Dimming the led strip off when the led light strip is fully on press and hold for more than second the down button on the remote transmitter. The awning s motor or remote control is usually to blame when the unit stops working as you expect. There s a dedicated circuit breaker for the power converter.

Press the neutral middle button on the transmitter. On many rigs it s located behind the rear wall of the pass through basement storage. The set is cream colored to match your awning s hardware perfectly. If it does continue to the next step.

Check power at the quick connect outlet or power source. When a desired dimming level has been achieved release the down button. Flip it off and back on and then recheck the test panel. If not replace the cr2430 battery.

How to use the multi channel remote transmitter see figures 13 14. Unplug the motor and plug it back in. Unplug the power cord from the wall. Test to see if this restored operation if not continue to the next step.