Safest Way To Attach Trellis To Wood Siding

Most hooks are stainless steel so they won t corrode and they are easy to remove when you re done with them.

Safest way to attach trellis to wood siding.

Drill holes and screw the boards for the trellis into place. The spacers we attached the trellis allows air to flow and prevent rot which is especially important if your house is sided with wood shingles. I was super worried about committing to nail holes or breaking the wall until i found the perfect hooks for hanging decor on vinyl siding without nails or screws. Securing a trellis to a wall properly includes attaching it through wall studs for sturdiness and using spacers for airflow between the trellis and the vinyl siding.

Our screened in porch has a wall of vinyl siding and i wanted to make it look nicer by adding some pretty decor. 1 first we consulted martha just to make sure we were on the right track and we were. Imo vine eyes and wires are by far the best way of attaching roses to a wall trellis even when attached to battens never allows enough ventilation between the house wall and back of trellis. Attaching your trellis to studs will make it more secure.

Attach the trellis to the 4 inch side of the boards to. Depends on what your siding is among other things. But i had no idea how to hang things on vinyl siding without damaging it. Screw two by fours to the back of the trellis using 3 inch wood screws and a power drill if the trellis would rest flat against the wall.

Use a stud finder available from home improvement stores to find and mark the locations on the wall with a pencil. Anyway i actually think trellis was always meant to be more free standing and viewed from two sides treillage. Use long metal fence posts pounded in ground not too close to house so damages to not incur to siding or foundation from vines also keeps bugs rodents from climbing up trellis onto house then attach the trellis to the metal posts using metal brackets these will provide adequate support for trellis plants on trellis and protection from the wind or storms knocking it over up against house causing damages posts at each side section of trellis if you are putting them beside each other depending. Place 2 inch deep by 4 inch wide 5 by 10 cm boards on the sides of the trellis.

2 next jesse cut small sections of scrap pressure treated wood for the spacers. I built a trellis for the roses around my front door from cedar i attached it to the house with stainless steel fasteners to avoid rust stains on the painted clapboards. It slips into the groove between adjoining slats and once it clicks into place you can hang items as heavy as 12 pounds. 1 hold your wooden trellis up.

Stabilize the trellis in its position.