Rv Awning Motor Maintenance

Always let the awning air dry don t use heaters.

Rv awning motor maintenance.

Solera awning motor wires remove the 3 bolts that hold the motor in place using a 10mm wrench or socket. You may have to rotate the motor slightly to get the gears to line up and then rotate it back in place to line up the bolt holes. This told me the motor and wiring to the awning was good. There is no purpose to take them out unless you want to replace the awning.

To wash your rv awning simply hose it off. You yourself can replace most parts of the awning apart from few things like fabric and awning arms. There can be several reasons for that and a repair man should be able to check on that. Step 3 fix warped rails.

Keep the water temperature less than 100 degrees fahrenheit. The manual advises using a mixture of cup bleach cup dishwashing liquid added to 5 gallons of water. You re just trying to get the dirt off not deep clean the awning. Our large 21 foot dometic 9100 rv power awning is made out of vinyl and has held up very well after 4 years of full time rving.

I tried the awning using it and it worked. Repairing the rv awning power switch. Electric rv awning operation is simple enough and easy to maintain. Rub down the rails pulley rollers and retracting arm to make sure they are not sticking due to friction rust or dirt.

This will work for both acrylic and vinyl awnings. By doing this the motor should start to operate and extend or retract the awning. If the awning is not appropriately set the chances of getting new tears and holes will increase significantly. I generally clean it every few months by following the procedure outlined in the owner s manual.

Tips to maintain your rv awning. Remove the bad motor and replace it with the new one. Ultraviolet rays from the sun will also take their toll on your awning. If that does not happen then the motor has gone bad.

Here are seven tips for regular rv awning maintenance. Protect your rv awning from the damaging effects of uv radiation. Locate the supply connection terminal on the motor and connect it with the battery supply wires that you will have. Inspect pull strap slide pins rv awning motor if its electric awning.

Don t remove end caps.